Fantasea-line Nano Flash Action 700 Lighting Set Manuel d'utilisateur télécharger pdf (Page 5)



Fantasea Nano Flash Instruction Manual 26110120

d. Install the Nano Flash Inside the Housing

i. Make sure that the both the Pre-Flash Mode Dial on the Nano Flash Housing

and the Pre-Flash Mode Control on the Nano Flash are 

position.

ii. 

iii. Insert the Nano Flash carefully into the front door of the housing, making

sure it seats fully.

iv. Prior to closing the Nano Flash Housing, the O-ring, positioned at the back

door, should be visually inspected. If there is any debris present, including

dirt, sand, dust, hair, grease or other matter, it must be cleaned to ensure a

proper watertight seal. Cleaning the O-ring is a simple matter of wiping it

with a damp, soft cloth to remove the foreign matter. Be careful the cloth

you use does not leave any of its own material behind, as this can also affect

the effectiveness of the seal.

v. It is recommended to apply a slight layer of silicone on the O-ring. Use the O-

ring Remover in order to remove the O-ring from its groove and make sure it

ut. Please

note that the amount of lubrication required on the O-ring is only enough to

allow it to slip into place without friction, so it does not twist or become

dislodged. More grease is not necessarily better, and in some cases might

interfere with the watertight seal of the Nano Flash Housing.

vi. When replacing the O-ring seal, place it back into the same groove you have

taken it out of. Be sure it is completely positioned in the channel for a proper

seal.

vii. Close the back door of the housing. Make sure you close it completely.

viii. Rotate the Dial Lock counterclockwise until

the Security Lock is pointed upwards. Lock

the Dial Lock by pushing the Security Lock in

(image #3).

e. Select the Proper Pre-Flash Program for Your

Camera

i. Please note that watching the Nano Flash

fire does not mean it triggers on the right

timing. If it is not synchronized with your

camera, this will usually result with

underexposed images.

Image #3

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Fantasea-line Nano Flash Action 700 Lighting Set Manuel d'utilisateur Page 5