Fantasea-line Nano Flash Action 700 Lighting Set Manuel d'utilisateur télécharger pdf (Page 4)



Fantasea Nano Flash Instruction Manual 26110120

b. Open the Nano Flash Housing

i. Release the security lock by gently pulling it out (image #1).

ii. Rotate the Dial Lock clockwise till it reaches an angle of 45 degrees (image

#2).

iii. Open the rear cover and take the Nano Flash out of the housing.

c. Install Batteries Inside the Nano Flash

i. Make sure that the Pre-

ii. Open the Nano Flash battery compartment by gently sliding the lid outwards

and then lifting it.

iii. Install 2 new AAA batteries according to the + and  marks found underneath

the battery compartment lid.

- Do not mix new and old or different types of batteries, as this may lead to an

over-discharge of the weaker battery, resulting with gassing or leaking of fluid

from the battery.

- P

rechargeable batteries.

iv. Close the battery compartment lid by gently pushing it down and then

inwards. Make sure that once you stop applying pressure on the battery

compartment lid, it remains closed.

v. Turn on the flash by turning the Pre-

properly installed, the Ready Light at the back of the flash should turn on after

a few seconds.

vi. When the Ready Light is on, the flash can be tested by turning the Pre-Flash



vii. Important Notice: Do not allow any drops of water to enter the battery

compartment when installing or removing batteries.

Image #1

Image #2

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Fantasea-line Nano Flash Action 700 Lighting Set Manuel d'utilisateur Page 4